3. Strain, stress and heat transfer during loading and release
Inspect the first and second mechanical periods, including the stress–strain response, heat-flow reversals and signed T–Q trajectories.
First period · Imposed strain and material response
The actuator imposes a straight strain ramp from 0 to −1,000 µε over 5 s, then returns to zero over the next 5 s. Stress is calculated from the evolving temperature and imposed strain. Heat initially leaves the warming solid, and continues to do so until 5.9324 s, after release has begun.
0.000 s · ε 0 µε · σ 0.0 kPa · solid 300.000 K · reservoir 300.000 K · heat into solid 0.0 W
Imposed engineering strain · Strain (µε)
Actuator command
Temperatures · Temperature (K)
SolidFinite reservoir
Signed heat flow · Power (W)
Positive into solid
Stress response · Stress (kPa)
Calculated axial stress
Stress–strain trajectory · Stress (kPa)
Compression then release
Stress deviation from the first compression chord · Stress deviation (kPa)
At 10 s the strain has returned to zero. The solid is at 298.449 K and the stress at zero strain has changed because the actuator holds the cooler solid at its original length. Subtracting the first compression chord magnifies the separation between the two stress–strain branches and preserves the net work integral over the return to the original strain.
Second period · Compression starts from a different state
Both temperatures carry through the 10 s boundary. The reservoir initially supplies heat to the cooler solid during the second compression. The second period has heat-flow reversals at 10.9162 s and 15.9151 s. The two stress-deviation traces use the same chord so their offset stays visible.
0.000 s · ε 0 µε · σ 0.0 kPa · solid 300.000 K · reservoir 300.000 K · heat into solid 0.0 W
Imposed engineering strain · Strain (µε)
Actuator command
Temperatures · Temperature (K)
SolidFinite reservoir
Signed heat flow · Power (W)
Positive into solid
Stress response · Stress (kPa)
Calculated axial stress
Stress deviation from the first compression chord · Stress deviation (kPa)
Period 1 compressionPeriod 1 releasePeriod 2 compressionPeriod 2 release
Temperature versus signed cumulative heat · Temperature (K)
The T–Q plot uses signed cumulative heat into the solid. Its horizontal direction reverses with the heat flow. At fixed deformation, the solid's slope magnitude is 30% smaller than the reservoir's because their capacities are 100 and 70 J/K. During deformation, the thermoelastic term also changes the solid temperature and therefore its plotted slope.